Das Hinterbaulager nach 1,5 Jahren. Wie man schnell feststellen kann ist die Abdichtung nicht besonders toll. Der erste Schritt beim Wechseln des Lagersatzes ist das Rauskloppen des großen Bolzens. Viel Spaß dabei Es geht einigermassen, wenn das gesamte Lager vorher mit WD 40 geflutet wird.
wie hast Du nur den Bolzen vom Schwingenhauptlager rausbekommen, Respekt. Wenn ich da von der linken Seite aus(nachdem ich als erstes die kleine Imbusschraube links rausgeschraubt habe) versuche den Bolzen nach rechts rauszuklopfen, finde ich schon mal gar keine Stelle, an der ich ansetzen könnte?!
Hello Chrif, Wet the whole thing on both sides with WD40, must be dripping. Wait 5 minutes. Take a "Gewindestang" M8x120mm, screw it in the hole where you have taken out the littel Imbusschraube. Take care it went in whole the way, by hand. Take a metal hammer and give one firm and straight shot, spot on the threaded rod. It will come out. When it is half out, use some WD40 and give it a second tick.
Bitte melde dich im Forum an um dieses Foto liken oder kommentieren zu können: Anmelden
Wet the whole thing on both sides with WD40, must be dripping. Wait 5 minutes. Take a "Gewindestang" M8x120mm, screw it in the hole where you have taken out the littel Imbusschraube. Take care it went in whole the way, by hand. Take a metal hammer and give one firm and straight shot, spot on the threaded rod. It will come out.
When it is half out, use some WD40 and give it a second tick.